Information PSi uses a lubricating oil “ISOFLEX PDP 61A” The manufacturer is: Fa. Klüber Lubrication Geisenhausener Straße 7 81379 München Tel.:0049 89 78760 www.klueber.de Alternatively, you can also use a good typewriters oil. Schmiermittel Datenblatt
The Absolute Pos goes. From always from the left edge. A Relative Position refers. To the last character. Example of print position 1/2 “(30/60”) from the left edge HEX : 1B 24 1E 00 DEC : 27 36 30 00 Horizontal Pos. Relative = from the last printing position HEX :1B 5C P1 P2 Draft…
Information It is recommended to use the PSi original printer driver and use of the application only internal printer fonts. TrueType fonts are fonts graphics printed with graphics speeds. However, if the need TrueType fonts to use, the PP40x) and all models offer the possibility of accelerating the Grafidruckes. In macro menu setting the print…
Information Use an internal font in your application. Enter Barcode commands and start / stop commands. These are described in the User Guide Barcode Quick Reference Guide. Use $$ instead of ESC [and select the Printers menu $$ – Emulation. The bar code is not shown on the screen.
Information Printed with the Font Data also bar with PSi sequences, optimizing performance is possible. The parameter P7 should preferably be set to the value “3” in the barcode sequence on the system side. Then the PSi barcode is printed in “NLQ unidirectional”. This is sufficient for most applications. Tests with readers, however, are recommended.…
Verlust von Einstellungen im Menü. Der Drucker hat plötzlich wieder Fabrikeinstellungen. Cause of The pull-up resistor for the Cond CTS (PIN 5 on 25-pol. Connector) is not due to + 12V to + 5V but. Thus, sending X-OFF / X-ON is non-connected at CTS -Ltg. suspended because the level does not min. 3V reached. Solution…
Information PSi used to lubricate the moving partsthe grease POLYLUB GLY 151 the manufacturer is Fa. Klüber Lubrication Geisenhausener Straße 7 81379 München Tel .: 004989 78760 www.klueber.de Schmierfett
Information The tear bar may in the installation menu in increments of 1 – are laid 360/60 up to 6 inches. Refer to the instruction. Verlegen der Tear off Position in PP80x