Possible cause 1:
The pressure of the Paper Guide 4 is no longer uniform.
Solution
Order numbers:
PP 404 – 5322 466 11768
PP 405 – 5322 466 11766
PP 407 / PP 408 – 5322 466 83095
Paper Guide 4 Remove the two green thumbscrews and test paper run, or changePaper Guide 4 of another printer. Check then the paper flow is braked. If with removed Paper Guide 4 the paper but not run properly with the new paper guide 4, then FF2 could not be installed properly. The rubber rollers must not rub against the sheet. Possibly the gear is right not deep enough on the shaft. Gear and shaft end must be flush. Game Wave permitted with gear 0.5mm.
Possible Cause 2:
The Belt Pulley’s are broken into the receiving pins.
Solution
Order numbers:
PP 404/405 – 5322 310 11313
PP 407/408 – 5322 310 32139
When the upper pulley is white, then it is an old pulley, which should be replaced by a black. Examination of Pulleys: screw and washer decrease Pulley must not be rotated by hand on the axis.
Possible Cause 3:
The FF-roller of V-Transports are worn out.
Solution
Order numbers:
PP 404 – 5322 310 11123 Kit V-Transport
PP 405 – 5322 310 31375 Kit V-Transport
PP 407/408 – 5322 535 93473 Shaft FF 1(only at feeding problems)
PP 407/408 – 5322 535 93474 Shaft FF 2
Diameter nominally 20.26mm, worn <20:15 mm
Possible cause 4: With PP405 / 408
Kit Cont. Forms or Kit Dollies is defective.
Solution
Order numbers:
PP 405 – 5322 310 31376 Kit Cont. Forms
PP 408 – 5322 310 10623 Kit Transport Roller (placed in cutter)
Possible cause 5: PP 407/408
Kit Tractor Exit is defective.
Solution
Order numbers:
PP 408 – 5322 310 10628 (iin the cutter)
PP 407 – 5322 310 10628 (last roller in the printer)
test freewheel: sideways driving gear by hand and fix the shaft by hand. Gear must not by ratcheting in the drive direction.
Possible Cause 6:
Paper Sensor (Paperin / run) no longer works reliably.
Solution
Order numbers:
PP 404/405 – 5322 693 22604
PP 407/408 – 5322 693 23162