Information Use an internal font in your application. Enter Barcode commands and start / stop commands. These are described in the User Guide Barcode Quick Reference Guide. Use $$ instead of ESC [and select the Printers menu $$ – Emulation. The bar code is not shown on the screen.
Information In Job should be additional sequences installed: ESC[;;;30 73 für Cut Mode OFF ESC[;;;31 73 für Cut Mode ON (after next Form Feed) ESC[;;;32 73 for cutting at the current position + 4mm For this please is the printer documentation observed. At job start “Cut Mode OFF” insert to prevent accidental cutting at FF.…
Information Printed with the Font Data also bar with PSi sequences, optimizing performance is possible. The parameter P7 should preferably be set to the value “3” in the barcode sequence on the system side. Then the PSi barcode is printed in “NLQ unidirectional”. This is sufficient for most applications. Tests with readers, however, are recommended.…
Verlust von Einstellungen im Menü. Der Drucker hat plötzlich wieder Fabrikeinstellungen. Cause of The pull-up resistor for the Cond CTS (PIN 5 on 25-pol. Connector) is not due to + 12V to + 5V but. Thus, sending X-OFF / X-ON is non-connected at CTS -Ltg. suspended because the level does not min. 3V reached. Solution…
Information Seriell-Adapter
Possible cause 1: The pressure of the Paper Guide 4 is no longer uniform. Solution Order numbers: PP 404 – 5322 466 11768 PP 405 – 5322 466 11766 PP 407 / PP 408 – 5322 466 83095 Paper Guide 4 Remove the two green thumbscrews and test paper run, or changePaper Guide 4 of…
Permanent vertical offset: Line prior to the first 1 – added 3 pages: Check Cause 2 or 3 Cause (FF2). Transport in the cutter slows down the paper path. To test Fold down the cutter and leave the paper running over the cutter. Printhead plate defective or soiled with glue / adhesive label. Remove roller and check…
Possible Cause: The roles of the Paper Guide 4 have swollen (circumferential speed is higher) and pull the paper with more train from the tractors. Abhilfe Paper Guide 4 5322 466 83095 austauschen. Mögliche Ursache 2 Der Andruck des Paper Guide ist einseitig. Das Papier wird zu einer Seite gezogen. Abhilfe Paper Guide 4 5322…
The HEXdump provides the ability to stream to analyze. It shows all control characters, which are sent to the printer. To this end, the HEX-DUMP is selected in the menu. Then you send the original file to the printer. All data are printed in HEX code line by line. Perform a HEX-DUMP PP40x_de_eng
Information The tear bar may in the installation menu in increments of 1 – are laid 360/60 up to 6 inches. Refer to the instruction. CHANGE TEAR OFF POSITION PP40x_de_eng