Permanent vertical  offset:

Line prior to the first 1 – added 3 pages: Check Cause 2 or 3 Cause (FF2). Transport in the cutter slows down the paper path. To test Fold down the cutter and leave the paper running over the cutter.
Printhead plate defective or soiled with glue / adhesive label. Remove roller and check the print head shield.
Typical error: When paper feed pushes the upper edge of the paper and moves or verreißt the paper.
Info: Check for repairing the correct locking of paper guide 4 Paper Guide 1, Loosen the crews and tighten.

Line 1 is too high, pressure is at perforation.
Paper sensor possibly replaced during repair and confused with the sensor of PP404 / PP407 405 or / 408th Check Adjust the printer’s menu and adjust as necessary. Paper bump (wave) before the first pair of rollers FF1:
The paper is already under FF2, cause almost always in the rear driving area.Tractor doors dawned tractor doors in tractor cassette has dawned and can slow down the paper depending on the paper thickness.
Solution: Replace Tarktorkassette
Paper is torn from the tractor, it incur slots at PP 407 and PP 408th

Possible Cause 1:
The roles of the Paper Guide 4 swollen (circumferential speed is higher) and pull the paper with more train from the tractors.
Solution: Paper Guide 4 5322 466 83095 exchange.

Possible Cause 2:
The pressure of the Paper Guide is one-sided. The paper is pulled to one side.
Solution: Paper Guide 4 5322 466 83095 exchange

Abhilfe

Prüfen Ursache 2 oder Ursache 3 (sporadisch auftretender Vertikalversatz).

Mögliche Ursache 2

Transport im Cutter bremst den Papierlauf

Abhilfe

Zur Prüfung den Cutter abklappen und das Papier über den Cutter laufen lassen.

Mögliche Ursache 3

Druckkopfschild defekt oder mit Kleber / Klebeetikette verschmutzt.

Abhilfe

Walze ausbauen und Druckkopfschild prüfen.

Mögliche Ursache 4

Typischer Fehler: Beim Papiertransport stößt die obere Papierkante an und verschiebt oder verreißt das Papier.

Abhilfe

Info: Nach Reparatur den korrekten Sitz von Paperguide 4, Paperguide 1 prüfen, Schrauben lösen und wieder festziehen.

Mögliche Ursache 5

1. Zeile ist zu hoch, Druck erfolgt auf Perforation. Papiersensor evtl. bei Reparatur getauscht und mit dem Sensor von PP404/405 oder PP407/408 verwechselt.

Abhilfe

Adjust im Menü des Druckers überprüfen und ggf. einstellen.

Mögliche Ursache 6

Papierbeule (Welle) vor dem ersten Rollenpaar FF1

Abhilfe

Das Papier ist bereits unter FF2, Ursache fast immer im hinteren Antriebsbereich.
Traktorklappe angebrochen: Traktorklappe in der Traktorkassette ist angebrochen und kann das Papier je nach Papierdicke bremsen.
Lösung: Tarktorkassette tauschen